Your furnace is a key part of your home. Without one, you wouldn’t be able to keep warm during the winter. Yet furnaces can have some issues that are more typical than others.

Let’s review these problems and discuss what they might cost to fix so you know before you contact an HVAC technician. Some of the most common furnace repair issues involve:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. My Furnace Can’t Start

There are a few reasons why your furnace won’t turn on, so make sure to check all of them.

  • Is your thermostat set correctly? Make sure it’s set to “heat,” “auto” and that your desired temperature is greater than the room’s current temperature. If you have a programmable thermostat, make sure it has fresh batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have power. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch located on or close to it. Since this switch resembles a light switch, it’s easy to unintentionally turn it off. If it was off, it might take your furnace a few minutes to start.
  • Is the air filter clean? A dusty air filter can cause a lot of problems for your furnace. Replace yours if you can’t see light through it.

Estimated Repair Cost

This issue can be complicated, so the estimated cost to repair it varies according to what’s wrong.

2. My Furnace Ignition System Isn’t Working

Your furnace follows a specific sequence when it begins heating your home.

  1. Your thermostat notices the temperature has dropped and tells your furnace to turn on.
  2. The draft inducer fan activates to pull in fresh air for combustion.
  3. The gas valve unlocks for the burners, which are ignited electronically.
  4. The flame sensor tells your furnace the burners have been ignited.

If something is wrong during the sequence, your furnace will shut off as a preventive measure.

A couple of potential causes for this issue include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t detect a flame, it will shut off your furnace to keep natural gas from getting into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may ultimately need to be taken out and changed.
  • Bad limit switch. This safety feature will shut off your furnace if it detects backdrafting. Backdrafting is hazardous, since carbon monoxide and natural gas can leak into your home. These switches can malfunction due to age, damage or dust accumulation.
  • Old thermostat. If your thermostat isn’t working properly, your furnace won’t be able to operate.
  • Dirty air filter. A dirty air filter can limit airflow and cause your furnace to shut off to prevent overheating. Make sure to change yours every 30 to 90 days, or whenever you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s important to note yours may vary based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. The Furnace Blows Cold Air

In many instances, this problem is tied to an incorrect thermostat setting or a dirty air filter that’s limiting airflow. Follow the steps above to fix the problem.

4. The Furnace Won’t Turn Off

If it’s very chilly outside or you like your home to be toasty, your furnace may be working for a long time.

If this isn’t what’s happening, ensure your thermostat is set correctly and working properly. If your fan setting is at “on,” the blower motor will be going even when the furnace isn’t, so it’ll sound like your furnace is running all the time.

Otherwise, there might be an issue with the blower motor or your ductwork may be leaking air, making your furnace run continuously to make up for the lost air.

Estimated Repair Cost

These costs are approximations, so it’s necessary to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

249 Air Will Work Hard to Get to the Bottom of Your Furnace Issues Quickly and Affordably

Furnace issues can be an expensive headache, but not when you call 249 Air. We’ve been delivering the quality, affordable furnace repair Houston homeowners have relied on since year. Call us at 832-263-1969 to request your free estimate today.